Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
iNSTALLATiON REQUIREMENTS
Your air conditionerwill installintostandard double hung
windowswith actual clearopening widths of 23to 36 inches
(584mrnto 914mm)(FIG. 1).
Lower sash must open sufficiently to allow a clear
vertical opening of 15 inches (381mm). Side louvers
and the rear of the air conditioner must have clear
air space to allow enough airflow through the
condenser for heat removal. The rear of the unit
must be outdoors, not inside a building or garage.
__
Sash
ei_
Window
Offset
Sill
I
;
_
Exterior
Interiorwall '_J
f?
FIG. 1
ELECTRICAL
SERVICE
Check your available electrical service. The power
supply available must be the same as that shown
on the unit nameplate (found on right side of cabinet).
All models are equipped with a 3-prong service plug
to provide proper service and safe positive
grounding. Do not change plug in any way. Do not
use an adapter plug. If your present wall outlet does
not match your plug, call a qualified electrician to
make the necessary corrections.
SAVE CARTON and this OWNER'S MANUAL for
future reference. The carton is the best way to store
unit during winter or when not in use.
To avoid risk of personal injury, property damage,
or product damage due to the weight of this
device and sharp edges that may be exposed:
• Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people
are needed to move and install the unit.
To prevent injury or strain, use proper lifting and
carrying techniques when moving unit.
• Carefully inspect location where air conditioner
will be installed. Be sure it will support the
weight of the unit over an extended period of
time.
• Handle air conditioner with care. Wear
protective gloves whenever lifting or carrying the
unit. AVOID the sharp metal fins of front and
rear coils.
=Make sure air conditioner does not fall during
installation.
INSTALLATION
HARDWARE
FIG. 2
iTEM
NAME OF PARTS
Q'TY
A
SIDE CURTAIN
2
B
SILL SUPPORT
2
C
BOLT
2
D
LOCK NUT
2
E
SCREW: 25/64"
13
F
SCREW: 5/8"
3
G
SCREW: 5/8"
5
H
FOAM STRIP
1
I
FOAM SEAL
1
J
L BRACKET
1
REQUIRED TOOLS:
,, Tight Fitting gloves
,, Standard screwdriver
,, Phillips screwdriver
• Pliers
,, Sharp knife
,, 3/8-inch open end wrench or adjustable wrench
,, 1/4-inch hex socket and ratchet
,, Tape measure
,, Electric drill
,, 1/4-inch drill bit
-5-
Publicidad
Tabla de contenido
