Set-Up Before Use; Pole Connector Assembly; Pole Assembly; Telescopic Pole Connector/Handle Assembly - Aqua EZ EV30 Manual De Usuario

Once the lifespan of the battery reaches its end, refer to section "BATTERY DISPOSAL"
for instructions regarding battery disposal.
NOTE: Let the pool vacuum rest for 30 to 40 minutes before charging it again.

Set-Up Before Use

Pole connector assembly

Press down the side pins of the connector and insert it inside the main body. Turn the
connector in either direction until the pin is secured in the hole, as shown in the diagram.

Pole assembly

Select the tube section with a threaded tip at the end. Insert and the threaded tip of the
pole section inside the pole connector and turn it clockwise to screw it inside. Finish the
assembly by inserting the grooved ends of the following section tubes in the round ends
of the remaining section tubes. The section with the grip is the last section to be
assembled.

Telescopic pole connector/handle assembly

Press down the side pins of the connector/handle and insert it inside the main body. Turn
the connector/ handle in either direction until the pin is secured in the hole, as shown in
the diagram.
12