aireRyder Cosmos Instrucciones De Instalacion Y Uso página 9

1. Pass the supply wires through
the hole in the mounting bracket.
Secure the mounting bracket to a
ceiling joist or other structural
ceiling element with two screws,
spring washers and flat washers.
Ensure that the support for the
mounting bracket is capable of
safely holding the moving weight
of the fan.
Receiver
Green/Yellow
5. Tuck all wires and the antenna
into the canopy. Push the canopy
upwards, lining up the keyholes on
the bottom with the screws on the
hanger bracket. Twist the Canopy
to lock it in place, then tighten the
screws to secure it. Attach the
decorative cap up to the canopy to
cover the screws.
8. Attach the fan light housing to
the mounting plate on the fan
housing by using the three fixing
screws. Ensure that you do not
trap any wires.
2. Hang the fan assembly with
the ball joint onto the mounting
bracket. Make sure the guide pin
of the bracket is fitted into the
corresponding slot of the ball
joint. You should feel the guide
pin setting into the slot of the ball
joint.
From House
Mounting
Bracket
6. Install the fan blades onto the
motor by tightening the screws
and washers evenly.
9. Install proper lamps to the
sockets (E14, max. 40W, not
included). Caution: To avoid risk
of fire, make sure the installed
lamps do not touch the reflective
cover of the fan light housing.
Slightly adjust the sockets if
necessary.
Depending on type of lamp used,
please select the correct setting
on remote control (button 6, see
below).
3. Install the remote control
receiver in the bracket as shown.
Make sure that you do not trap
any wires.
4. Make wire connections. Follow
diagram on the left and make sure that
all exposed wires are tightened by screw
on terminal block.
Note:
a.) The terminal block shown in left
graph is pre-installed on the mounting
bracket.
b.) Wires from house may vary in color
and may not include ground wire
(yellow/green). After wiring is completed,
gently push wires into junction box with
terminal block upward (if applicable).
c.) Do not cut the gray sensor wire in
any situation.
7. Connect the black wire to the
black wire by connectors.
Connect the blue wire to the
blue wire by connectors.
Connect the green wire to the
green wire by connectors.
10. Install the glass shade onto
the fan light housing using three
set screws and plastic washers.
Check to make sure the screws
securing the glass shade are
finger tight, but not
over-tightened.