Publicidad
Idiomas disponibles
Idiomas disponibles
About the automatic icemaker,
gecom
A newly installed refrigerator may take 12 to 24 hours to begin making ice.
Automatic Icemaker
Power
Switch
Icemaker
Green
PowerLight
The icemaker
will produce
seven cubes
per cycle----ai)i)roxin/ately
100-130
cubes
in a 24-hour
period,
depending
on fl'eezer
coi//l)ai'tillent
tei//l)ei'attli'e
_ i'ooi//
teml)erature,
munber
of door openings
and other
use conditions.
See below fin" how to access ice and reach
the power switch on dispenser
models.
If the reti_igerator
is operated
betore
the
water connection
is made
to the icemakei;
set the power switch in the 0 (off) position.
When
the refl-igerator
has been
connected
to the water supply, set the power switch to
the I (on) position.
The k'emaker
will fill with water when it
cools to 15°F (-10°C).
A newly installed
refi_igerator may take 12 to 24 hours to begin
making
ice cubes.
You will hear a buzzing sound each dine
the k'emaker fills with watei:
Throw awm the first tew batches
of ice to
allow the water line to clem:
Be sure nothing
interteres
with the sweep
of the teeler ram.
When
the bin fills to the level of the teeler
aml, the icemaker
will stop producing
ice. It is noi_nal tin" several cubes to be
joined
togethei:
If ice is not used fl'equenfl>
old ice cubes
will become
cloudy, taste stale and shrink.
NOTE."In homes with lower-than-averagewater
pressure,you may hear the icemaker cyclemultiple
times when making onebatch of ice.
Models without a shelf
above the ice bin
Toaccessice andreach the
icemaker rowerswitch:
o
Lift flTe bin, thenpull it
forwarduntil the bin stops.
Lower the bin to access ice
or reach the power switch.
NOTE:In order to take full advantage
of the tilt-out ice bbL only store items
on the shelf below the ice b#7that
are no tafler than the Iowest pohTt
on the bin.
Accessing Ice and Reaching the
Power Switch on Dispenser Models
There are two types of ice storage bins on
dispenser models. One has a shelf aboxe
tile bin, the other
does not.
Special note about dispenser models
without a shelf above the ice bin:
i_:These
models
have a tilt-out ice bin.
The bin can be tilted ()tit as shown ill
the illustrations,
and it will hold itself
up while you take ice ()tit or turn the
icelnaker
power switch on and off.
Be sure to put the bin back in place
befiwe closing the dooi:
To restore
your ice level from
an empty
s e,
ste s
12 hom_ after the fiI_t batch
of ice
has tidlen into the bin, disl)ense
3 to 4 cubes.
@
_Mter an additional
6 hems,
dispense
3 to 4 cubes again.
Models with a shelf
above the ice bin
Toaccessice, pullthe binforward.
Toreach the power switch, pull the
shelf straight out Always be sure to
replace the shelf.
These steps will restore
your ice level
ill the shortest
ai//otint
of tilne.
11
I
,,,><,,,,,,,,,,,,,,,,,,
ii!iiiiii_i_iiiii
w
g
N"
i
H
Publicidad
