Installing The Network Camera; Wall Mount; Ceiling Mount; Connecting The Cables - Axis 215 PTZ-E Installation Guide

AXIS 215 PTZ-E Installation Guide

Installing the network camera

There are two ways of mounting the camera - wall mount and ceiling mount. Follow the
appropriate instructions below.
Note:
Use protective covers for the cables that are in compliance with the IP-66 rated, outdoor-proof
design of the AXIS 215 PTZ-E.

Wall mount

1. Using the provided drill template, drill four holes in the wall.
2. Place the AXIS 215 PTZ-E network camera to the wall and attach it using four screws
appropriate to the wall material.

Ceiling mount

The AXIS 215 PTZ-E is shipped with an NPT adaptor. See www.axis.com for a list
of available mounting brackets.
1. Remove the wall bracket by taking off the four screws attached to it, using
the 5mm allen key provided.
2. Remove the sunshield (optional) by taking off the three screws attached to it, using the 5mm
allen key provided.
3. Attach the supplied NPT adaptor onto a pole mount
bracket.
4. Attach the AXIS 215 PTZ-E network camera to the NPT
adaptor using the four large screws.

Connecting the cables

1. Connect the 5m CAT5E network cable to the network.
2. Connect the 5m power cable to a 100-240VAC, 1.2A, 50/60Hz power connector, according to
the following table:
Warning -
High voltage! The electrical connection should be made by an authorized electrician. Please
observe relevant national and local regulations for the installation.
Input100-240 VAC
L N GND
brown blue yellow-green
Wall
bracket
Pole
mount
bracket
(1.5 inch)
o-ring
NPT adaptor
o-ring
Page 5