Usb; Operating Dc Appliances; Replacement Parts - PowerStation PSX3 Manual Del Propietário

USE OF THE PSX3
Note: If the maximum pressure of the item being inflated is not known, then allow the compressor
to run only until the desired fullness is reached. Over-inflating an item could result in damage to
the PSX3 or the item being inflated. Never leave the compressor running unattended.
Operating USB powered devices
The PSX3 USB Output Supplies Power Up To 1 Amp At 5V DC
The USB power outlet does not support data communication.
1. Ensure the battery clamps are securely placed on the posts located on the back of the unit.
2. Plug your device into the USB port (USB cable is not included).
3. Unplug the USB device from the PSX3.
4. Charge the PSX3.
Operating 12V DC appliances
To power a 12V DC appliance with your PSX3 please follow these steps:
1. Plug in appliance to the 12V outlet.
2. Turn on appliance.
3. After use is completed, turn off appliance, unplug appliance from the unit.
4. Re-charge the PSX3 as soon after use as possible.
5. Check the battery voltage regularly when using the 12V outlet. Do not allow the battery
voltage to drop below 11V before recharging or damage to the battery can occur.
Notes:
• The 12V DC outlet and USB outlet are always on. No other switches need to be on to use
this outlet.
• The combined load should not exceed 15 Amps. Outlet will switch off automatically if
overloaded.
• The PSX3 will NOT automatically turn off power to the DC outlet or USB. Continuing to use 12V
DC appliances or USB powered devices after the battery has been depleted can permanently
damage the unit.
• Do not operate 12V DC appliances or USB powered devices while charging your PSX3. Doing
so may damage the unit and/or your DC appliance or USB powered device.
• 12V DC appliances vary greatly according to the amount of power they consume. The wattage
consumed by a 12V DC appliance will impact the length of time the PSX3 will operate the
appliance before the need to recharge the PSX3. The greater the wattage consumed, the lesser
the duration of the PSX3 battery charge. The 12V DC outlet is equipped with an internal circuit
breaker which will automatically cut power to the outlet if: the DC appliance causes a direct
short or if the appliance draws excessive amperage. This circuit breaker is designed to
automatically reset once the fault has been corrected and the breaker has cooled to a normal
operating temperature.

REPLACEMENT PARTS

The following replacement parts are available for the PSX3:
PART
NUMBER
RSPS151
RSPS152
RSPS155
Only parts identified by part number are available for purchase.
If you experience any problems with the PSX3, please DO NOT return the unit to the
place of purchase. Please call PowerStation's Technical support staff between the
hours of 8:30 AM to 5:30 PM Eastern Standard Time toll free at 1-800-837-5994.
031413
DESCRIPTION
120V AC power cord
12V DC power cord
Inflation accessories
continued
PSX3 Owners Manual Page 13