Moen nedia Guía De Configuración página 11

OPTIONAL LOWER BRACKET MOUNTING WITH SCREWS
acket (B) within the marking STEP B1:
arrow is pointing up and the
Push the button on the top of the bracket to release the top of the bracket from the wall.
ainst the wall.
l, mark the center of the left and
Tilt the top toward you until the tube comes out of the adapter. Lift the bracket up, then
ong the horizontal axis of the
pull off of the wall to remove. The lower bracket will remain on the wall.
bracket from the wall.
nsula (B) dentro de la marca
énsula quede contra la pared.
STEP B2:
marque el centro de los agujeros
erecho a lo largo del eje horizontal
For tile: use a ¼" drill bit, and drill holes through the holes in the lower mounting
a.
sula de la pared. bracket into the wall.
pport de montage (B) à l'intérieur
t que le support est placé contre
STEP B3:
crayon, marquer le centre des
és gauche et droit, le long de l'axe
For tile: use a ¼" drill bit, and drill holes on the marks. Insert the anchors into
support.
pport de montage du mur.
the holes. Insert the screws.
STEP B4:
Line up the bottom of the bracket to reinstall, then pull down, and push the tube
0668A - 6/19
back into the adapter until you hear a "click".
" deep.
" diám.) y perfore hasta una
a brida del ancla quede a ras de la
mique « A » seulement (diam. 1/4
mur jusqu'à ce qu'ils soient de
Visit moen.com/nebia for tips and videos.
Button
¼"
10