Descargar Imprimir esta página

Installing The Parrot Minikit Smart; Installing The Phone; Charging The Parrot Minikit Smart - Parrot MINIKIT Smart Guía De Instalación Rápida

Ocultar thumbs Ver también para MINIKIT Smart:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 23
Installation

Installing the Parrot MINIKIT Smart

Warning:
Avoid any installation which could hinder the
use of any important command or hinder the driver's
visibility. Do not install the Parrot MINIKIT Smart in the
airbag deployment area or in a possible head impact
area. Make sure it is not exposed to the air stream from
air vents.
Clean the area with an appropriate cleaning product
then mount the craddle on the windscreen (diagram 1
p.4). To do so, press the suction cup against the
windscreen and lift the locking lever until the
mounting kit is correctly fixed.
The cooling and heating cycle inside your vehicle may
cause the suction cup to detach from the windscreen.
Make sure the suction cup is properly affixed to the
windscreen each time you use the Parrot MINIKIT
Smart. If it is not the case, the device may fall whilst
driving. Reinstall the suction cup if necessary.
Install the Parrot MINIKIT Smart on the mounting kit
(diagram 2 p.4). To release the Parrot MINIKIT Smart,
press the release buttons on the craddle (diagram 6
p.7).
Extract the microphone from the Parrot MINIKIT
Smart and use the provided clips to install it on the
sunvisor or on the dashboard (diagram 3 p.5).

Installing the phone

Install your phone on the Parrot MINIKIT Smart by
inserting its upper side first (diagram 4 p.6).
If your phone supports the GPS feature, install it in an
easily accessible and visible location.

Charging the Parrot MINIKIT Smart

The Parrot MINIKIT Smart must be charged before
being used for the first time. To do so, plug the
charger into your vehicle's cigar lighter or connect the
Parrot MINIKIT Smart to your computer using a USB/
mini-USB cable (diagram 5 p.6).
The LED located next to the mini-USB port turns on
to indicate that the battery is being charged. The LED
turns off once the Parrot MINIKIT Smart is fully
charged. It takes around 2 hours to charge the Parrot
MINIKIT Smart.
When the battery level is low, the Parrot MINIKIT
Smart emits a series of beeps. The Parrot MINIKIT
Smart will turn off approximately 15 minutes later.
English
9

Hide quick links:

Publicidad

loading