GE PGP989 Manual Del Propietario E Instrucciones De Instalación página 16

PARTS INCLUDED (PACKED BELOW THE COOKTOP)
• Blower assembly
• Blower plenum
• (4) Nuts (10-32 keps – nuts with
lock washers attached)
• (9) Sheet metal screws
(8-18 x 3/8")
• Foam gasket tape (9-ft. roll)
• Vent grille
• Vent filter
Check to be sure that all packing materials
and tape have been removed. This will include
tape on control knobs (if applicable), adhesive
tape, wire ties, cardboard and protective
plastic. Failure to remove these materials could
result in damage to the appliance once the
appliance has been turned on and surfaces
have heated.
Burner Grate (2)
CAUTION:
GLASS IS FRAGILE
DO NOT BUMP EDGE
OF GLASS DURING
INSTALLATION
Blower Assembly and (4) Mounting
Nuts (10-32 keps – nuts with lock
washers attached)
Installation Instructions
UNPACKING YOUR COOKTOP
• Vent grille gasket
• Cleaning cream
• Scrub sponge or scraper
(on some models)
• Burner grates
• Burner heads
(1 small (A), 2 medium (B),
1 large (C))
Reflective Tape
Regulator
Burner Caps and Burner Heads
Burner Cap and Burner Head
Foam Gasket Tape
Cleaning Cream
Scrub Sponge
Vent Grille
Vent Grille Gasket
16
• Burner caps
(1 small, 2 medium, 1 large)
• Gas pressure regulator &
LP Conversion Instructions
• Attached 120-volt grounded
plug cord
• Reflective tape
Sheet Metal Screws (9)
(8-18 x 3/8")
CAUTION:
DO NOT LIFT
FROM VENT
OPENING OR
BUMP GLASS
Burner Cap and Burner Head
Blower Plenum
Vent Filter