UL De 30 Manual De Instrucciones Para La Instalación, El Uso Y El Mantenimiento página 10

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Blower
electrical
connection
Connect
the 5-pin
plug on the blower
assembly
to
the matching
5-pin
receptacle
on the bottom
of the
cooktop.
Fold all wires into the wire box on the end of the blower
conduit.
Fasten the wire box to the cooktop
with two #8
x 3/8"
making
sure that no wires are trapped.
Install
Pressure Regulator
Install the pressure regulator with the arrow on the
regulator
pointing
up toward
the unit in a position
where you can reach the access cap.
_DO
NOT make the connection
too
tight. The regulator
is die cast. Overtightening
may
crack the regulator
resulting
in a gas leak and possible
fire or explosion.
Figure 21 - CONNECT BLOWER TO COOKTOP
Connecting
the Ductwork
Connect
the ductwork
prepared
in Steps 8, 9 and 10 to
the blower
transition
duct.
Manual
GAS FLOW
Pressure
Shutoff
Flare
I_
Flare
Regulator
Valve
Union
Union
0n_!;_
t
t
Nip1'le_p
__.
Nipple
Flexible
Access
Off
Connector
Cap
All connections must be wrench-tightened
Figure 22 - GAS SUPPLY LINE
Assemble
the flexible
connector
from the gas supply
pipe to the pressure regulator
in the following
order:
1. manual
shutoff
valve
2. 1/2" (1.3 cm) nipple
3. 1/2" (1.3 cm) flare
union adapter
4. flexible
connector
5. 1/2" (1.3 cm) flare
union adapter
6. 1/2" (1.3 cm) nipple
7. pressure regulator
Use pipe-joint
compound
made
for use with Natural
and LP/Propane
gas to seal all gas connections.
If
flexible
connectors
are used, be certain
connectors
are
not kinked.
............
_j
Figure 22B - PHYSICAL ATTACHMENT OF THE GAS
LINE TO THE COOKTOP
10

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

De 36

Tabla de contenido