Tc 1. Directives References; Tc 2. Hazards; Tc 3. Warnings - ThermoKey TMC Serie Manual Tecnico

ThermoKey Heat Exchange Solutions
SUMMARY
TC 1. DIRECTIVES REFERENCES
TC 2. HAZARDS
TC 3. WARNINGS
TC 4. INTENDED USE
TC 5. INSPECTION, HANDLING AND TRANSPORT
TC 6. INSTALLATION AND COMMISSIONING
TC 7. GENERAL MAINTENANCE AND CONTROL
TC 8. WIRING DIAGRAMS OF FANS
TC 9. DIMENSIONS - TECHNICAL DATA

TC 1. Directives references

The product described in this manual is compliant with:
MACHINERY DIRECTIVE 2006/42/EC
LOW VOLTAGE DIRECTIVE 2006/95/EC
ELECTROMAGNETIC COMPATIBILITY DIRECTIVE2004/108/EC
PED DIRECTIVE 97/23/EC (2014/68/UE STARTING FROM 19/07/2016)
ERP DIRECTIVE 2009/125/EC
07 MT TC R MC EN 04 2017

TC 2. Hazards

07
Danger of electrocution. The product is equipped with electric fans with an operating nominal voltage of 400V AC three-
08
phase or single phase 230V. The power supply lines must be fitted with protection systems against electric shock and equipment
protection devices as required by law.
08
09
Risk of cutting. The heat exchanger, integral part of the product, is made of metal fins with unprotected sharp edges. The casing
09
is made of metal sheet components that in some points may present unprotected sharp edges.
11
Danger of moving parts. The product is equipped with electric fans fitted with a protection grid as provided by law. For
11
some products it could be possible to deliberately access moving parts (motor fan blades) from unprotected areas. Before
12
any access, please make sure that moving parts do not constitute a hazard to operators.
13
Danger of squashing limbs or persons. During handling, transportation and installation, operation and maintenance,
pay maximum attention to the indicated weight of each product to prevent tipping over or dangerous falls towards the
operators.

TC 3. Warnings

TC 3.1
Contents of the Technical Manual of the Product:
GENERAL INSTRUCTIONS FOR SAFE USE (I.G..)
INSTRUCTIONS FOR HANDLING AND UNPACKING (I.M.)
INSTRUCTIONS AND TECHNICAL DATA (T.C.)
SPECIFIC INSTRUCTIONS FOR USE AND MAINTENANCE (I.S.)
TC 3.2
This manual is section TC called INSTRUCTIONS AND TECHNICAL DATA of the Technical Manual of the Product.
For any information not covered in this manual, please refer to the other sections (I-II-IV) and, if in doubt, contact
the Manufacturer.
TC 3.3
This manual is an integral part of the TMC model and as such it must be kept throughout the operational life of the product.
TC 3.4
Any additional technical documentation regarding non-standard products is attached to this manual, becoming an
integral part of it and it is identified with a specific code indicated on the shipping documents.
TC 3.5
The product described in this manual is considered a partly completed machine, therefore not usable as supplied
but is a component for air conditioning and refrigeration systems and must be installed and commissioned only by
qualified operators (see chapter on installation and commissioning).
Technical Manual TC Instruction and technical data
MT TC R MC EN 04 2017 08