Saivod SAP 717 Manual De Instrucciones página 80

Installation in a sliding sash window
1. Cut the sponge B to a proper length and attach it to the window stool.
2. Open the window; place the window panel on the window stool vertically; slide the adjust-
ment plate to make the window panel close to the window stools at the upper and lower
side of window; fix the window panel on the windowsill with screws and clips of rear conn-
ection plate. (required quantity is shown in the sheet below)
Window height (H)
H≤28"(520mm)
28"(520mm) H≤36.5"(927mm)
36.5"(927mm) H≤64"(1625mm)
3. Cut the sponge B to a proper length and attach it to the window panel.
4. Close the window securely against the window panel.
5. Cut the sponge A to a proper length and seal the gap between left side of inner window
sash and outer window sash.
6. Fix the inner window with window bracket and screw, so that it can not slide horizontally.
outer window
Screw quantity Clip quantity
sponge B (adhesive)
plastic window
sponge A
inner window
wooden window
sponge B (adhesive)
2 2
3
3
4 4
80
window stool
window
sash
windowsill
window
window bracket
sash
clip of rear
connection
plate
Window
height (H)