Choice The Cycle; Start The Cycle; Drying Off; Stop Temporary And Completely The Cycle - Mocom millwashing Manual De Instalación Y Operador

CHOICE THE
CYCLE
START
THE CYCLE

DRYING OFF

STOP TEMPORARY
AND COMPLETELY
THE CYCLE

END OF CYCLE

12
SHORT PROGRAM
NORMAL PROGRAM
INTENSIVE PROGRAM
Check for detergent in the internal container and the materials properly loaded:
1. Close the door and switch on the unit by pressing the key
2. Select the desired cycle (the key's Led turns on),
3. Press the START key
The cycle starts and goes though a series of programmed phases. The display shows the
current value of temperature. The door is blocked throughout the cycle.
Press this key to exclude the forced drying phase from the selected cycle.
Press this key if you need to stop the cycle in execution; the key's red Led switches on.
The failed disinfection is signaled by flashing the red Led
From this condition you can:
-
resume the cycle from the start by issuing a new START command,
-
or select a new STOP command to definitely stop the cycle; the door is unblocked
and the signaling on the display goes back to the standby status.
T STOP
HE KEY IS DISABLED DURING THE FINAL DRYING PHASE
In conditions of normal operation, the cycle continues up to the completion of any phases.
At the end of the cycle the green Led
completion of the cycle.
Suitable for materials not very dirty.
1
Washing only with detergent and thermo-
disinfection at 93°C for 1 minute.
Suitable for materials normally dirty.
2
Pre-washing, washing with detergent and
thermo-disinfection at 93°C for 3 minutes.
Suitable for materials specially dirty.
3
Intensive pre-washing, washing with detergent
and thermo-disinfection at 93°C for 10 minutes
(the key's Led turns on).
NOTE
turns on to signal the successful
,
.
.