Instructions Of Use - INDUSTRIAS TECHNOFLEX KN-16 Manual De Instrucciones

1B
OPERATION
1.7

Instructions of use

a) – POWER ON
1.- Turn the engine switch to "ON".
2.- Screw the fuel valve to "ON".
3.- Push the choke valve lever to "ON".
4.- Push the throotle lever one or two step
5.- Pull the andel until feeling resistant,
Pull the rope andel slightly and then jerk immediately when you feel resistant.
Hold the handle and let it go step by step with the rope bouncing back.
6.- Warnings for operating rammers at high altitudes:
When using standards oil machines, the air with low oxygen content will make the
concentration of oil in the oil-gas mixtures too high, wich will result in the reducted level of
efficiency of engine and the increase of the consume of oil. Therefore, it is necessary to
change the nozzle of the carburetor with a smaller aperture and readjust the idle speed of
the carburetor in order to improve the performance of the engine. But under the condition
that the nozzle of the carburetor is fitted, the power of the engine will still reduce about
3.5% with each 300 metres raise of the sea level.
b) - USING THE RAMMER
1.- Open the choke on the carburetor alter Stara, warm up for about 5 min.
2.- Pull the operador handle, pull the accelerograph control handle to the
the backmost end.
3.- Guide rammer withits handle, allow machine to pull itself forward.
1B-6
rightward.
then pull the rope and Stara the engine.
ATENTION
ATENCIÓN
ENGLISH