Features - Surtek RM535A Manual De Usuario

Rotomartillo electroneumatico
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

FEATURES

KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
1
5
1. TOOL HOLDER(SDS-PLUS).
2. GUIDE RULER.
3. OPERATING MODE SELECTOR KNOB.
4. TRIGGER.
5. AUXILIARY HANDLE.
ASSEMBLY INSTRUCTIONS
WARNING: Remove the grinder from the
carton and examine it carefully. Do not discard
the carton or any packaging material until all
parts are examined.
• Check the power supply
The power tool supply must match the name-
plate date.
• Automatic safety clutch
Protects the operator and machine from the
high reverse torque, which develops if the tool
jams all of a sudden.
INSTALLING THE AUXILIARY HANDLE
Unplug the tool from the
mains socket, firstly. Re-
lease the auxiliary handle
clamping band by turning
the handle in a counter-
clockwise direction.
Then fit the handle band over the chuck and
onto the cylindrical section at the front end
of the tool. Pivot the auxiliary handle into the
desired position. Finally, tighten the handle se-
curely to prevent inadvertent movement.
E N G L I S H •
WARNING: Use the auxiliary handle supplied.
Missed operation will cause bodily harm.
SELECTION OF TOOLS
For hammer drilling, SDS-plus tools are neces-
sary that are inserted into the SDS drill chuck
of the machine.
2
For drilling in steel or wood, driving screws
and cutting threads, tools without SDS-plus
(e.g., drills with cylindrical shafts)are used. For
4
these tools, a special drill chuck is required
(see APPLICATIONS).
INSERTING/REMOVING SDS-PLUS TOOL
The SDS-plus tool is designed to be freely mov-
3
able. This causes eccentricity when the machine
is not loaded. However the drill automatically
centers itself during operation. This does not
affect drilling precision.
WARNING: Take care when changing tools
that the dust cap is not damaged.
a) Inserting: Clean the tool before inserting
and lightly grease the insertion end.
Insert the tool with a twisting motion into the
tool holder until it locks. The tool locks itself.
Check the locking by pulling on the tool.
U ser' s manual
11

Publicidad

Tabla de contenido
loading

Tabla de contenido