General Characteristics; Safety Warnings - IGNIA LIGHT SEQUOIA Manual De Instalación Y Mantenimiento

ENGLISH
IMPORTANT: The instruction manual you are holding includes essential information on the safety measures to be im-
plemented for installation and start-up. Therefore, the installer as well as the user must read the instructions before
beginning installation and start-up.
Keep this manual for future reference.
1. VERIFY THE CONTENTS OF THE PACKING:
• Sequoia Luminaire (I2801)
• Instruction manual

2. GENERAL CHARACTERISTICS:

This Class I (230 V~) electrical appliance has a protection degree of IP66 and IK10.
Made of cast aluminum.
3. ASSEMBLY:
The Sequoia lighting fixture is held up by a bracket mount.
In the version with asymmetrical optics arrows on the front indicate the direction of the light output.
Electrical connection with 2 poles cable + Earth.
4. IMPORTANT INFORMATION:
This luminaire is designed for outdoor and indoor lighting.
The maintenance or replacement of any component must be made with identical or failing with those recommended
by SACOPA, SAU. It is the responsibility of the installer or final assembler, any impact resulting from the assembly has
not been conducted in accordance with this instruction sheet.
5. MAINTENANCE:
For optimum performance of the luminaire is recommended periodic cleaning of the exterior of the glass, depending
on environmental conditions. Use a very mild soapy cloth with mild detergent.
If replacing the power supply, follow these steps:
1. Disconnect the fixture from power source.
2. Open the cover of the luminaire.
3. Disconnect the input power source (230Vac).
4. Disconnect the power supply output that connects to the LED board.
5. Replace the source.
6. Reconnect the cables in and out while maintaining the same polarity.
7. Close fitting lid.

6. SAFETY WARNINGS:

• Do not stare directly into the luminaire when it is on. This could damage the eyes.
• People will assemble must possess the necessary qualifications for such jobs.
• Avoid making contact with electric voltage.
• Comply with the current standards regarding accident prevention.
• In this regard, the IEC-364-7-714 standard must be observed: ELECTRICAL INSTALLATIONS OF BUILDINGS.
OUTDOOR LIGHTING INSTALLATIONS.
• All service must be performed with the fitting disconnected from the network.
• The manufacturer in any way responsible for the assembly, installation or operation of any manipulation or addi-
tion of electrical components that have not been conducted on the premises.
3