Publicidad
INSTALLATION INSTRUCTIONS - ENGLISH - STEP BY STEP GUIDE
1. Remove diffuser (4) from housing (2)- near one end of
housing, grasp edge of diffuser and carefully squeeze to
release diffuser from housing. Continue down length of
diffuser to fully disengage.
2. Remove fixture components and parts pack(s). Check
that all parts are included. See page 2.
Warning: Safely dispose of packaging materials.
Assistance may be required to support fixture during
installation.
Turn off power at fuse or circuit breaker box!
NOTE:
This fixutre requires to be surface mounted using a
standard ceiling junction box (hardware included).
Depending on your mounting-hole spacing, knockout
removal may be required.
To remove knockouts:
Place standard screwdriver on center of slot and gently strike
with hammer. Grip edge with pliers and flex back and forth until
removed.
3. With the power turned off, thread two Screws (1) into
junction box (Note: screws must be the same distance apart
as keyholes in back of housing assembly).
Assistance may be required to support fixture during
installation.
WIRING AND FIXTURE OPERATION CAUTION:
Connect fixture to supply wires rated for at least 90°C (194°F).
Do not use fixture on dimming circuits. Consult a qualified electrician to
ensure adequate supply wire
4. Hold the fixture Fixture Housing (2) firmly and connect
the green ground wire from the fixture to the bare copper
ground wire from the junction box using a Wirenut (3). (If
house wiring does not include a ground wire, consult your
local electrical code for approved grounding methods).
5. Use Wirenuts (3) to connect the black fixture wire to the
black power supply wire and the white (neutral) fixture wire
to the white power supply wire. See Fig 1.
FOR PROPER CONNECTION, PLACE WIRENUT OVER
WIRES, TWIST CLOCKWISE UNTIL TIGHT.
6. Hold Fixture Housing (2) in one hand and with the other
hand position wires up into junction box.
7. Align keyholes on back of Fixture Housing with screws (1)
previously installed in junction box. Lift fixture up, rotate
clockwise and tighten screws to secure Housing Assembly
against ceiling.
rating.
8. Set up proper CCT - position switch (5) to select color
temperature of 30K (warm), 40K (cool) or 50K (day light).
9. Install diffuser (4) - install one side of diffuser to housing,
then another side as showed in Fig. 2. Confirm that diffuser
is fully engaged with both sides of housing.
10.Turn on electricity at fuse or circuit breaker box and
verify success of installation.
Trouble Shooting Guide
If this fixture fails to operate properly, use the guide below
to diagnose and correct the problem.
Verify that fixture is wired properly.
Verify that fixture is grounded correctly.
The line voltage at the fixture is correct.
If further assistance is required, contact:
Technical Support at: (800) 748-5070
This LED light provides low maintenance service with no
bulbs to change.
Cleaning Diffuser: For best results, diffusers should be
washed with soap or mild detergent. Rinse with clear wa-
ter and allow to air dry.
Page 4
U219651T 11/17
Publicidad
