Wall Thermostat Installation - Hotpoint AH11E07D Manual Del Propietario E Instrucciones De Instalación

Wall Thermostat Installation (Optional)
IMPORTANT
contact your local electrical contractor, dealer, or
distributor for assistance.
Thermostat Wire Routing
Thermostat wire is field supplied. Recommended wire
It is recommended that extra wires are run to unit in
case any are damaged during installation. Thermostat
through, the wall sleeve. The wire should then be routed
behind the front panel to the easily accessible terminal
connector.
NOTE: Refer to thermostat installation instructions for
details on installing wall thermostat.
(OFF).
locations.
• Insert the wires from the wall thermostat into the correct
terminals according to manufacturers instructions.
49-5000041 Rev. 3
Installation instruction for PTAC Thermostat
Remove the two screws as shown below and remove the
cover.
Terminal of PTAC Wall Thermostat (MODE A)
Terminal
Compressor (Y)
Remove the 2 screws
Remove the covers
Thermostat connection
terminals
Designation
7