Klein Tools DTL304 Manual De Instrucciones página 7

• Press "
• Press "ENTER" to display "
If "
• Press "ENTER" to display choice number 3 in the secondary
display and
• Press "
Off Time choice number you want, and then press "ENTER" to
store the Auto-Power-Off setting in memory.
• Auto-Power-Off mode is automatically disabled in MIN/MAX
and logging modes.
H. Change Logging Interval
• The logging interval determines how often the thermometer
stores logged readings in memory. You choose the length of
the logging interval. The thermometer stores logged readings
at the end of each logging interval.
• Select logging intervals
1. :01 sec
2. :10 sec
3. 1:00 min
• Press "
• Press "ENTER" to display the logging interval choices.
• Press "
interval you want, and then press "ENTER" to select.
• For user-defined logging interval (1 sec. to 23 hrs : 59 mins).
Press "
and then press "ENTER" to select. The last number in the
time display blinks.
Press "
appears on the display, and then press "ENTER" to select.
• Holding down "
more quickly.
I. Setting Temperature Offset
• You can adjust the thermometer's readings to compensate
for the errors of a specific thermocouple. The allowable
compensation range is ±5.0°C or K, and ±9.0°F. The DTL304
allows you to store individual offsets for T1, T2, T3 and T4.
• Press "
• Press "ENTER" to display T1 reading (blinking), T1 offset.
• Press "
display to select 1 input.
• Press "
correct reading, and then press "ENTER" to store the offset
setting in memory.
• NOTE: Reset the offset to 0.0 when it is no longer needed.
• NOTE: If T1, T2, T3 or T4 has no offset, " OFFSET "will not be
displayed.
J. Resetting The Thermometer
• To restore to factory settings, press "
the display shows "
"
1. Connecting Thermocouples
• Thermocouples are color coded based on the ANSI color code:
J Type = Black
K Type = Yellow
• Plug a thermocouple into the input terminal(s).
• Set the thermometer for the correct thermocouple type. To
change the thermocouple type, see:
Set Up Instructions section, Set Up Instructions section,
Set Up Instructions
" or " " until the display shows "
" is displayed, press "
00:30 h:m in the time display.
" or " " until the display shows the Auto-Power-
" or " " until the display shows
" or " " until the display shows the logging
" or " " until the display shows "h:m" or "m:s",
" or " " until the logging interval you want
" or "
" or " " until the display shows " OFFSET ".
" or " " to display T1, T2, T3 and T4 in the primary
" or " " until the primary display shows the
" in the primary display. Press "EXIT" to exit setup.
FUNCTION INSTRUCTIONS
" or " " in the time display.
" or " " to select "
4. 10:00 min
User Defined
" causes the number to change
" or "
" then press "ENTER" to display
T Type = Blue
E Type = Purple
F: Thermocouple Type
".
".
and " LOG ".
" until
7