Troy-Bilt 01924 Manual Del Usuario página 11

Section 4: Operation
[n an emergency, use the original shipping carton as a
7. Cut off aHH carton flaps.
8. Cut out one Hong side of carton to expose muffler side
of unit as shown in Figure 7.
iMPORTANT: The generator must be at [east 5 ft.
(H52 cm) from structures having combustibHe waHHs and/or
other combustible materials. Leave at least 3 ft. (92 cm) all
around generator incHuding overhead, for adequate cooHing,
maintenance and servidng.
WARNING
DO NOT touch hot surfaces,
Allow equipment to cool before touching.
The generator" must be at least 5 feet from structures having
combustible walls and/or other combustible materials.
. Keep at [east 3 feet of clearance on all sides of generator for
adequate coding, maintenance and servicing.
Remove shelter when temperatures are above 40°F [4°C].
9. Cut appropriate shotsto access receptacles of unit.
HO.Start unit, then pHace carton over it.
NOTE: Remove shelter when temperatures are above
40°F [4°C].
For a more permanent shelter, buiHd a structure that will
encHose three sides and the top of the generator.
7. Hake sure entire muffHeroside of generator is exposed,
as shown in Figure 7.
iMPORTANT: The generator must be at Heast 5 ft.
(H52 cm)
from structures
having
combustibHe walls and/or
other combustibHe materiaHs. Leave at Heast 3 ft.
(92 cm)
aHH
around generator
including
overhead, for
adequate cooling
maintenance and
servicing.
8. Face
exposed
end away from wind and dements.
9. Structure shouHd hoHd enough heat created by the
generator to prevent icing problem.
H0. Start and run engine outdoors.
HH. Keep exhaust gas from entering a confined area
through windows, doors, ventilation intakes or other
openings.
DANGEN
Operate generator ONLY outdoors.
Keep exhaust gas from entering a confined area through
windows, doors, ventilation intakes or other openings.
DO NOT operate generator" inside any bowing or enclosure,
inchding the generator compartment of a recreational vehicle
(RV),
12. DO NOT enclose generator any more than shown in
Figure
7.
H3. Remove sheHter when temperatures are above 40°F
[4°q.
14. Turn engine OFF and let cool two (2) minutes before
refueling.