Fagor ASTRA Serie Manual De Uso página 12

0
Identifi cation
Identify your washer-dryer model ("a", "b" or "c")
by comparing the control panel with the illustrations.
1
Installation
1.1 Unpacking (1.1.1, 1.1.2 and 1.1.3). Remove
the bolts and the fi xing and blocking elements
used for transport.
1.2 Connection to the water mains (1.2.1, 1.2.2
and 1.2.3). If the washer-dryer has a hot water
intake, connect the hose with a red connector
to the hot water intake (1.2.4). Always use the
new hose supplied, removing any previously
used hoses.
1.3 Drain. IMPORTANT! Place the hose in
the drain in accordance with the measurements
shown on the drawing.
1.4 Levelling. Correctly level the washer-dryer to
prevent any noise or shifting. The recommended
procedure is as follows: 1. Position the rear
legs and fi x them in place (1.4.1); 2. Place the
washer-dryer in its fi nal location (1.4.2); 3. Posi-
tion the front legs and fi x them in place (1.4.3).
1.5 Electrical connection. Take the electrical data
on the reference plate into account.
1.6 Installation under a worktop. If you need
to remove the worktop to recess-mount the
washer-dryer, contact your dealer or the Techni-
cal Assistance Service.
Recess dimensions are 600x600x850.
2
Operation
2.1 Opening the loading door. Open the loading
door.
2.2 Detergent and additives. Sort items by colour,
soil and fabric type before loading the washer-dryer.
The detergent drawer has the following
compartments: wash
fabric softener
All the washer-dryers are designed to use deter-
gent powder (2.2.2). All the washing machines
are designed to use powder detergent (2.2.2). If
you wish to use liquid detergent (2.2.3), you will
see a blue tab for this purpose in the wash com-
partment. Pull it outwards as far as it will go,
then release it. It will remain in vertical position
(2.2.4), this will prevent the liquid detergent from
running out. To use powder detergent again,
place the blue tab in horizontal position and
10
, prewash and
(2.2.1).
push it back as far as it will go to open the fl ap
(2.2.5).
Remember you must not exceed the MAX level
marked on the fabric softener compartment.
2.3 Switching on and selecting the wash and
dry programme. Select the was programme
(2.3.1) using the control panel, after consulting
the programme chart (page 12). To select the
drying time, press the drying button
You may select automatic or manual drying.
The fi rst time the drying button is pressed "aut"
(automatic drying) will appear on the display.
When you press the button again, a manual
drying time of 00 min will appear, increasing
according to the mode the button is pressed in:
Mode 1 -> if you hold the button down
the drying time will increase in steps of 10
minutes (from 00 min to 170 min).
Mode 2 -> press and release the button the
time increases 1 minute each time the button
is pressed.
2.4 Selecting the spin speed. You may choose
a spin drying speed or cancel out spin drying
(2.4.1, 2.4.2). If you select Anti-crease
(2.4.3) the wash process will pause before the
fi nal spin and the clothes will be left submerged
in water Press to run the fi nal spin dry.
AVERAGE RESIDUAL
DAMPNESS* (%)
600
COTON programmes 80
80
SYNTHETIC programmes
100
WOOL programmes
QUICK programme 100
*Residual dampness: the degree of dampness of the
clothes on completion of the spin dry phase
The drying function times given below are
for guidance only and will vary depending on
the number and size of the garments and the
composition of the load. The maximum load
admitted is 5 kg.
Guide to drying times
Fabric
Cotton
Mixed
LOAD TYPE:
Bath towel 800 gr
Bath towel 400 gr
Trousers (adult) 700 gr
Trousers (child) 400 gr
Cotton shirt (adult) 200 gr
e n g l i s h
(2.3.2).
MAXIMUM SPIN SPEED OF THE
MACHINE (r.p.m)
800 1000 1200 1400
71 62 53 52
70 70 70 70
90 90 90 90
90 80 80 80
RPM
Load 1000 1400
5 kg 170 min. 155 min.
3 kg 140 min. 120 min.
4 kg 130 min. 120 min.
2 kg 90 min. 80 min.
Polyester cotton shirt 150 gr
T-shirt 250 gr
Pyjamas 300 gr
Lingerie 50 gr
Sheets 600 gr