Installation; Delivery Check; Preinstallation - Nederman Vacuum Blaster Manual De Usuario

1 bar 2 bar
Ø 8,0 0,59 1,18
Nm /min Nm /min
3 3
4

Installation

WARNING! Risk of personal injury.
Blasting activities can result in static electricity and/or sparks. Consult local authorities
or your supplier for suitable measures to avoid any risks.
NOTE! Always respect local regulations regarding installation and use of
Vacuum Blaster.
4.1

Delivery check

If there are any damaged or missing parts when the product is delivered, notify the
carrier and the local Nederman representative immediately.
4.2

Preinstallation

Make sure Vacuum Blaster is placed on a straight and steady surface. Take
Vacuum Blaster's weight into account as well as the weight of blasting media and
operator.
NOTE! Do not expose Vacuum Blaster to water and/or moist since this makes the
blasting media clog.
NOTE! Dry and clean compressed air is required. An after cooler with separator (and
filters) is necessary. In a fixed execution this can be achived with a dryer and air receiver.
4.3 Installation
WARNING! Risk of personal injury.
The compressor's pressure must not exceed 8 bar.
Install the Vacuum Blaster as follows:
1. Mount the coarse grain separator, see figure 1 item 9, on top of the blast pot, see
figure 1 item 7.
2. Connect the vacuum air hose, see figure 1 item 10.
NOTE!
Before fastening the separator, rotate it so the hose does not bend.
3. Before connecting the vacuum hose, see figure 9 item 8, bend the inside spiral
copper wire outside the hose. Connect the hose to the rubber coupling on the inlet
and fasten using the clips, see figure 10.
NOTE! Make sure not to fasten the hose too tight.
4. Connect the vacuum hose to the pre separator, see figure 1 item 9.
5. Connect the blast hose, see figure 11 and figure 9 item 3.
3 bar 4 bar 5 bar
1,77 2,36 2,95
Nm /min Nm /min Nm /min
3 3 3
6 bar 7 bar 8 bar
3,55 4,14 4,73
Nm /min Nm /min Nm /min
3 3 3
Vacuum Blaster EN
9 bar 10 bar
5,32 5,91
Nm /min Nm /min
3 3
19