Publicidad
Idiomas disponibles
Idiomas disponibles
1
OPERATION
2
Sanding operation
CAUTION:
• The tool should not be in contact with the
workpiece surface when you turn the tool on or
off. Otherwise a poor sanding finish or damage
of the belt may result.
Hold the tool firmly with both hands. Turn the
tool on and wait until it attains full speed. Then
gently place the tool on the workpiece surface.
Keep the belt flush with the workpiece at all
times and move the tool back and forth.
Never force the tool. The weight of the
2
3
tool applies adequate pressure. Excessive
pressure may cause stalling, overheating of the
motor, burning of the workpiece and possible
kickback.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off
and unplugged before attempting to perform
inspection or maintenance.
Replacing carbon brushes
1. Limit mark
1
1
1
1
Remove and check the carbon brushes
regularly. Replace when they wear down to the
limit mark. Keep the carbon brushes clean and
free to slip in the holders. Both carbon brushes
should be replaced at the same time. Use only
identical carbon brushes.
1
1. Screwdriver 2. Brush holder cap
Use a screwdriver to remove the brush holder
caps. Take out the worn carbon brushes, insert
the new ones and secure the brush holder
caps.
T o m a i n t a i n p r o d u c t S A F E T Y a n d
RELIABILITY, repairs, any other maintenance
or adjustment should be performed by TAKIMA
Authorized or Factory Service Centers, always
using TAKIMA replacement parts.
ACCESSORIES
2
1
CAUTION:
• These accessories or attachments are
recommended for use with your TAKIMA tool
specified in this manual. The use of any other
accessories or attachments might present a
risk of injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details
regarding these accessories, ask your local
7
2
1
1
Publicidad
