Mutsy IGO Serie Manual De Instrucciones página 17

in this position. Make sure the two straps on either side of the seat are
attached to the press studs on the canopy (t6).
Folding the frame with the seat facing forwards (u)
· Stand behind the chassis and put the chassis on the brake. Fold the
hood back if it is folded out. Fold the seat unit in two by tilting the back
support forwards (s1).
· Push the height adjustment button (s2) of the pushbar in and move
this to the lowest setting. Pull the folding safeguard (s3) towards you
on both sides and turn the pushbar forwards until the pushbar lies on
the frame (s4).
· Pinch the chassis unlocking buttons and fold the chassis (s5).
· The folding safeguard locks automatically when the product is folded up.
· The integrated carry handle, which is located under the rear axle, has
made lifting and carrying the folded pushchair more practical.
· NB! The chassis cannot be folded with the seat facing backwards!
Unfolding the frame with the seat
· Press the folding safeguard inwards (a1) and tilt the upper frame until
the lower support clicks into place (a2) and move the push bar back-
wards until you hear a second click (b).
· After unfolding the seat, always push the bumper bar to its upright po-
sition before placing a child in the seat. Make sure that no child is near
the bumper bar when moving it.
· Before use always check that the pram has been unfolded and secured cor-
rectly.
The hood (v1, v2)
· Hold the front hood bar in the centre and move it forwards or rear-
wards to adjust the hood (v1)
· Open the zipper at the back of the opened hood in order to enlarge it.
Close the zipper to again reduce the hood (v2)
· Pull the flap on the front side of the hood outwards to additionally en-
large the hood. Push the flap inwards to again reduce the hood.
Assemble the rain cover on the pushchair (w)
· Make sure that the hood of the seat is in the upright position.
· Open the zipper in the rain cover in order to attach it to the enlarged
hood of the seat.
· Place the rain cover from top to bottom over the pushchair and make sure
that the rain cover is attached well behind the back support and over the
leg support.
EN
11