Publicidad
Idiomas disponibles
Idiomas disponibles
[] Channel
Selection
Selectchannels b y pressing [OH•/V]
or [the Numberbuttons],
[] Volume
Adjustment
Thissection describes h owto adjustthe volume,Themutefunction, w hich
turnsthesoundoff andon,isals0described,
• To select the memorized
channels,
use [CH •Iv]
or
[the Number
buttons].
• To select the non-memorized
channels,
use
[the Number
buttons].
To Use [the Number
buttons]
When selecting
analog channel
12
When selecting
digital
channel
12-I
Be sure to press [-] before entering
the minor
channel
number,
• Press [CH RETURN] to return to the previously
viewed channel.
About digital TV broadcasting:
With its high definition
broadcast,
digital
broadcasting
far surpasses analog broadcasting
in both its picture
and sound quality.
What
is the minor
channel?
By using high compression
technology,
digital
broadcasting
offers a service that enables
multiple
signals to send simultaneously,
Therefore,
you can select more than one program
per
major channel
since digital
broadcasting
technology
distinguishes
between
multiple
channels broadcast
by
a single network.
NTSC (analog mode) [Air Time]
ATSC (digital mode)
18:00
18:30
19:00
19:30
20:00
20:30
major c
I
minor channel
: change automatically
_:> : change manually by using [CH •I
V]
Note:
• "No Signal" will appear on the TVscreen after the minor
channel broadcast is over.
• "Audio only program" message will appear on the TV
screen, when you receiveonly sound signal.
Use [VOL.
I
] to adjust the audio volume,
• The volume
bar will be displayed
at the bottom
of
the TV screen when adjusting
the volume,
• The volume
bar will automatically
disappear
in a few
seconds.
Press [MUTE D_] to turn off and on the sound.
M
• "Mute"
is displayed
on the TV screen for a few
seconds.
Press [MUTE D_] again or [VOL.
I
] to recover the
original
volume,
[] Sleep Timer
Thesleeptimer can beset to automatically turn offthe unit after an
incremental period of time.
Press
[SLEEP]
to set the sleep
timer.
• Sleep timer display appears on the %/screen.
2
Press [SLEEP] repeatedly
to change the amount
of time
until shut off,
• You can set your unit to turn off after a set period of
time (from 30 to 120 minutes),
• Each press of [SLEEP] will increase the time by 30
minutes.
• After setup, the sleep timer display can be called up
for checking
by pressing
[SLEEP],
To Cancel
the Sleep
Timer
Press [SLEEP] repeatedly
until "Sleep Off" is displayed
on the TV screen.
Note:
• The sleep timer display will automatically disappear in a
few seconds.
• When you disconnect the unit from the AC outlet or when
a power failure occurs,the sleep timer setting will be
canceled.
EN
Publicidad
