Remove Transport Lock; Operation - Kärcher FP 303 Manual De Instrucciones

Remove transport lock

Illustration
Remove the transport locks the first
time you use and before using the appli-
ance by pulling them off.
Assemble the strut and attach it
Illustration
Assemble both parts of the strut and se-
cure with the enclosed screw and nut.
Insert the entire strut into the polishing
head and attach with a screw.
Note: Here, take into account the loca-
tion of the mains cable.
Illustration
Press the mains cable into the attach-
ments and tension it.
Connect suction hose
Illustration
Insert the straight end of the suction
hose into the polishing head, insert the
bent end into the strut connection.
Inserting the cloth bag
Illustration
First, push the upper part of the cloth
bag into the intake until it locks.
Then attach the bottom part to the strut
using the Velcro pad.
Inserting a filter bag
Illustration
Open the zipper of the cloth bag.
Insert the filter bag and slide the carton
with the opening over the support until it
locks into place. Recheck the correct
positioning of the filter bag.
Close the zipper on the cloth bag.
Insert pad holder
Illustration
Place the appliance on the floor so that
the polishing head is positioned perpen-
dicular to the surface.
Simply press the pad holder into the in-
take. Ensure that the noses of the pad
holders lock well into the intake.
To remove the pad holders, simply pull
them off.
Insert the polishing pads
Illustration
Install the polishing pads on the pad
holders and ensure that they are cen-
tered properly.
To remove the polishing pads, simply
pull them off.
Storing the polishing pads
The polishing pads can be stored in a
separate compartment in the bottom
part of the cloth bag.

Operation

Note:
Always work with the filter bag inserted.
Caution
Before inserting the mains plug, ensure
that the strut is located in a vertical position.
The appliance is switched off in this posi-
tion.
Illustration
Turn the upper cable hook and remove
the mains cable. Insert the mains plug
into a socket.
Illustration
Press hold down the unlocking key. Pull
the shaft in the rear direction. The de-
vice is activated.
To stop the appliance, bring the strut
back to the vertical position until it locks.
– 5
EN 11