Hisense 12К Manual De Instrucciones página 17

● Do not install the indoor unit in a machinery shop or kitchen where vapor from oil or its mist flows
to the indoor unit . The oil will deposit on the heat exchanger, thereby reducing the indoor unit
performance, and may deform and in the worst case, break the plastic parts of the indoor unit.
●Pay attention to the following points when the indoor unit is installed in a hospital or other facilities
where there are electronic waves from medical equipment, etc.
(A)Do not install the indoor unit where the electromagnetic wave is directly radiated to the electrical
box, remote control cable or remote control switch.
(B)Install the indoor unit and components as far as practical or at least 3 meters from the
electromagnetic wave radiator.
(C)Prepare a steel box and install the remote control switch in it. Prepare a steel conduit tube and
wire the remote control cable in it. Then, connect the ground wire with the box and the tube.
(D)Install a noise filter when the power supply emits harmful noises.
● To avoid any corrosive action to the heat exchanger , do not install the indoor unit in an acid or
alkaline environment. In an application where the indoor unit is to be utilized under such
environmental conditions, it is recommended that the corrosion-proof type unit be used.
Check to ensure that the number of below is within 0.3kg/cm³. Otherwise it may cause
danger situation if the refrigerant in the Outdoor Unit leaks into the room where this Indoor
Unit is installed.
Installation and Maintenance
12