To Replace Hydraulic Jack Oil; Lubrication - Husky HD7024A Guía De Uso Y Mantenimiento

Maintenance (Continued)

TO REPLACE HYDRAULIC JACK OIL

1
Opening the Release Valve
Open the release valve by
turning handle
counterclockwise.
3
Draining the Old Oil
Turn entire jack over so that
all of the old oil will drain
out of the oil fill hole.
Note: when draining oil, use a
proper container and always follow
all local and state waste disposal guidelines.
5
Releasing Pressurized Air
Rapidly pump jack handle 6
to 8 strokes to release any
pressurized air.
IMPORTANT: When adding or replacing oil, ALWAYS use a
good grade of (SAE 5W) hydraulic jack oil. NEVER use brake
fluid, alcohol, glycerin, detergent motor oil or dirty oil of any
kind. Improper oil usage will cause serious internal damage to
jack.

LUBRICATION

1
Oil When Needed
Use a good grade of
lubricating oil on all moving
parts when needed (arm
linkages, front wheels and
rear casters).
2
Removing the Plug
Remove oil fill plug.
4
Leveling the Jack
After all of the old oil has drained out of
the jack, turn the jack back over to a level
position fill with new oil.
6
Filling with New Oil
Using a good grade of SAE
5W hydraulic jack oil, fill
the reservoir to the
bottom of the threads in
the oil fill hole. Replace
and tighten oil fill plug.
Do not allow dirt and
debris to enter the system.
2
Grease the Lifting Assembly
Grease the lifting arm
assembly through its
grease fitting, using a
good grade of multi-
purpose chassis grease.
7
Please contact 1-888-HD-HUSKY for further assistance.
WWW.HUSKYTOOLS.COM