Listening To The Radio; Troubleshooting - LOTRONIC BOOST-TOWER100 Manual De Uso

necessary.
• After successful pairing, the LED indicator will flash slowly
USB/SD PLAY
• Insert the USB key or micro SD card on the speaker and press MODE button to enter into MUSIC mode.
• Press VOL+/VOL- button to adjust the volume
• Press  or  button to choose your music
• Press on  button to choose play/pause status.

LISTENING TO THE RADIO

• Press MODE button to choose FM mode, the LED indicator will flash in green
• Press on  button on the speaker or on the remote control, all available stations will be searched and then
stored in memory automatically.
• Press  or  button to select 20 presets.
AUX INPUT
• Press MODE button to choose AUX IN status. The LED indicator will flash in red.
• Use an Aux cable (included) with one 3.5 mm stereo plug on each end of the cable.
• Plug one end into the AUX jack on the main unit and plug the other end of the cable into the Line-out or
Headphone Jack of your external audio appliance
• Turn ON your external audio appliance
• Use the control on your Bluetooth enabled appliance to control the volume
TROUBLE-SHOOTING
If the product is not operating properly, make a check of the items in the table below. If the problem persists,
a malfunction may be assumed. Disconnect the power immediately and contact the store where the unit was
purchased.
PROBLEMS
No function light or no sound Plug is not connected well
Function light is ON but no
sound
SPECIFICATIONS
Output power ........................................................................................................................................ 100W
Impedance .......................................................................................................................................... 4 Ohms
Frequency response ...................................................................................................................60Hz – 18kHz
FM band ................................................................................................................................... 87.5 - 108MHz
Bluetooth frequency .............................................................................................................2402 – 2480MHz
Max. RF output power ......................................................................................................................-9.06dBm
Mains adaptor ......................................................................In : 100 – 240V~ 50/60Hz 0.3A; Out : 5V�� 1.5A
Dimensions ..................................................................................................................... 190 x 190 x 975mm
Weight .................................................................................................................................................... 2.9kg
The above specifications are for reference only. Design and specifications are subject to change for improvement without prior
notice.
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To
prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to
promote the sustainable reuse of material resources. To return your used device, please use the return and collection
systems or contact the retailer where the product was purchased. They can take this product for environmental safe
recycling.
4
REASONS
Cable is disconnected
Failed when connect to the
Bluetooth appliance
Volume was set at 0 de-
gree or at mute status
SOLUTIONS
Insert plug into the electric outlet
Turn off the power check the input jack to ensure
the proper signal is connected to relevant input
jack
Connect the Bluetooth appliance properly make
sure it was connected successfully
Add the volume at the proper degree or press the
MUTE key again on the remote