Publicidad
3.2 INSTALACIÓN DE LA FUENTE DE ALIMENTACIÓN.
POWER SUPPLY INSTALLATION.
1
The power supply can be installed on a DIN slide (figure A) or by
means of sleeper-screws into the wall but always internally (figure B),
but always internally.
4. CONFIGURACIÓN.
4.1 PROGRAMACIÓN DE LAS CLAVES DE ACCESO.
PROGRAMMING ACCESS CODES.
PROG
LED
LED
PROG
LED
LED
CONFIGURATION.
PROG
2
connections. Assemble the protection piece using
the two screws of the power supply.
The user can configure up to six access codes, each of them
containing a minimum of 3 digits and a maximum of 7 digits. By
default, the module is provided with 1-2-3-4-5-6 programmed for
code number 1. The access codes are programmed in the
following way:
a) Press the PROG pushbutton located at the back of the
module. The LED indicator will light up.
b) The first number pressed will be the code number to be
programmed (1 to 6). The module will make a confirmation
sound.
c) The numbers pressed after this will make up the access code
one wishes to programme. The module will make a
confirmation sound and the LED indicator will turn off
momentarily each time a key is pressed. If more than seven
digits are pressed, the module will make an error sound and
exit programming mode.
d) Once the code desired has been typed in, simply press the
PROG pushbutton once again for the code to be stored and
the module to exit programming mode. The module will
make a confirmation sound and the LED indicator will turn
off. If less than three digits are pressed, the code will not be
stored and the module will make an error sound.
To delete a code, follow steps a) and b), and then press the
PROG pushbutton once again. The code will be deleted and the
module will make a confirmation sound. The LED indicator will
turn off.
Perform
Publicidad
