Programming Favorite Channel Scan; Re-Assigning Device Keys - One for All URC8820N Guia Del Usuario

Programming Favorite Channel Scan

In the TV, VCR, DVD, and CBL/SAT modes, you can store a list of
up to 10 favorite channels, in any order, that will be immediately
scanned when you press FAV (see "Using Channel Scan").
NOTE: Only channels of one mode can be stored for Favorite
Channel Scan.
1. On the remote control, press TV, VCR, DVD, or CBL/SAT once.
Press and hold SET until the LED (red light) blinks twice, then
2.
release SET.
Enter 9 9 6. The LED will blink twice.
3.
4. Use the keypad to enter a favorite channel number (e.g., 031).
Then press SET once.
NOTE: If the original remote control required pressing an
ENTER key to change the channel, also press the ENTER key
after the channel number (e.g., 0 3 1 ENTER).
5. If desired, repeat step 4 (in this section) for each favorite
channel to be stored, up to a total of 10 channels.
NOTE: If you try entering more than 10 channels, the remote
control will automatically exit programming.
To exit programming, press and hold SET for 3 seconds. The
6.
LED will blink twice.

Re-Assigning Device Keys

You can set this remote to control a second TV, VCR, DVD player,
or other device. For example, to control a TV, a cable box, and two
DVDs, you will need to re-assign the AUX key to operate the second
DVD as follows:
1. On the remote control, press and hold SET until the LED (red
light) blinks twice, then release SET.
2. Enter 9 9 2. The LED will blink twice.
Press DVD once, then press AUX once.
3.
The AUX key is now ready to be programmed for your second
4.
DVD. See "Setting Up Your Components."
To re-assign other device keys to the AUX key, repeat steps 1
through 4 by substituting the sequence from the following chart:
To Re-Assign Device
AUX as 2nd TV key:
AUX as 2nd VCR key:
AUX as 2nd CBL/SAT key:
AUX as 2nd CD key:
AUX as 2nd PVR key:
AUX as 2nd AUD key:
You can also re-assign another unused device key by substituting
an open key for the AUX key in the above chart and performing
the sequence. For example, to re-assign an unused CBL/SAT key
as a 2nd CD key, perform SET - 9 - 9 - 2 - CD CBL/SAT. When a re-
assignment is done, the LED (red light) will blink twice to confirm
your choice. At that time, you will need to program the remote
control for the new device (see "Setting Up Your Components").
12
Perform Sequence
SET - 9 - 9 - 2 - TV - AUX
SET - 9 - 9 - 2 - VCR - AUX
SET - 9 - 9 - 2 - CBL/SAT - AUX
SET - 9 - 9 - 2 - CD - AUX
SET - 9 - 9 - 2 - PVR - AUX
SET - 9 - 9 - 2 - AUD - AUX