Celestron POWERSEEKER 127AZ Guía De Instalación Rápida página 2

Q U I C K S E T U P G U I D E
E N G L I S H
1
Unpack your telescope and verify that all parts are present. Your
PowerSeeker 127AZ with Smartphone Adapter includes: a telescope
tube, a tripod and altazimuth mount head, an accessory tray, two
eyepieces (H20mm and SR4mm), a 3x Barlow lens, a fi nderscope, a
metal smartphone adapter, and a Moon fi lter.
4
Place the threaded post on the metal accessory tray onto the center
of leg brace and turn the tray to thread it in place.
7
Secure the slow motion control rod to the telescope tube by attaching
the included bolt and tightening.
127AZ
#22040
2
To set up the tripod, loosen the hand knobs at bottom of each leg.
Extend the legs of the tripod by unlocking the three thumbscrews on
each leg. Pull each leg section all the way out and tighten the knobs
to secure the legs in place, being careful not to overtighten.
5
Tighten the top leg hinge thumb bolts at the top of each leg to ensure
the tripod is secured.
8
Line up the tube with the holes on the mount and secure the tube to
the mount using the two threaded mounting bolts. Tighten to secure
in place.
3
Loosen the top hand knobs and spread the legs outward until they are
fully extended. Push down the center leg brace.
6
Locate the telescope tube and insert the attached slow motion
control rod into the hole on the mount. NOTE: The slow motion
control rod may not come attached to the telescope tube. See step
7 for proper installation of the rod.
9
Loosen the setscrews on the eyepiece tube, remove protective cap
and insert the 20mm eyepiece into tube. Snug the set screws back
down to secure the eyepiece in the tube.
E NG LISH | 1