Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Features
Top Panel
51
64
54
64
57
60 60 60
58
65
61 61 61
59
65
36
31
34
35
35
38
39 40 41
27
42
43
44
45
45
1. Input Selector: Set this switch to the desired audio source from this channel: PC (a track
playing on that layer in the software), Line (a device connected to the Line Input on the
rear panel), or Engine (a track on a connected USB flash drive; Decks 1 and 2 only).
Please note that the Line/Phono selector switches on the rear panel must also be set
properly. Also, a channel's controls will only send MIDI information when its Input
Selector is set to PC.
2. Channel Level: Turn this knob to adjust the level of the pre-fader, pre-EQ audio signal for
the channel.
3. Channel Level Meters: These LEDs display the audio signal level of the channel.
4. Channel EQ: Turn these knobs to boost or cut the high, mid-range, and low frequencies
for the channel.
5. Channel Filter: Turn this knob to adjust the filter applied to the channel. Turn the knob
counterclockwise to apply a low-pass filter. Turn the knob clockwise to apply a high-pass filter.
6. Channel Cue: Press this button to send the channel's pre-fader signal to the headphones'
cue channel.
7. Channel Fader: Use this fader to adjust the channel's volume level.
8. Crossfader Assign: Routes the audio playing on the corresponding channel to either side
of the crossfader (L or R), or bypasses the crossfader and sends the audio directly to the
program mix (center, Thru).
4
52
53
50
55
62
63
56
32
46
47
26
33
48
37
16
10
18
17
1
2
17
4
16
18
4
17
4
17
3
3
5
19
6
6
20
8
8
21
49
28
7
29
30
10
10
1
1
1
2
2
2
4
4
4
4
4
4
4
4
4
3
3
5
5
5
6
6
8
8
7
7
7
9
13
10
14
15
15
12
11
25
24
23
22
Publicidad
Tabla de contenido
