Basic Settings - BEARWARE 302688/20171207FZ006 Manual De Instrucciones

Indoor temperature display:
The measured value should not be below the minimum value (-9.9°C / 14°F) or
above the maximum value (50°C / 122°F).
Outdoor temperature display:
The measured value should not be below the minimum value (-40°C / -40°F) or
above the maximum value (70°C / 158°F).

8. Basic settings:

Note: Firmly touching the top of the housing will switch on the backlight.
After the "SNOOZE/SLEEP" button is released, it switches off again after 5
seconds. Please note that the base station does not respond to 2 buttons at
the same time. It is therefore advisable to press only one button.
Press and hold the "MODE" button for about 3 seconds to configure the basic
settings. With the "+" and "-" buttons you can change the values accordingly.
24
The indoor temperature is measured by the base
station and is shown with an accuracy of one
tenth of a degree. The configured temperature
unit is displayed to the right of the measured
value. The temperature unit can be changed
between ° C and ° F. This has to be configured in
the basic settings.
The outdoor temperature is measured by the
outdoor sensor and shown with an accuracy of
one tenth of a degree. The configured tempera-
ture unit is displayed to the right of the measu-
red value. The temperature unit can be changed
between ° C and ° F. This has to be configured in
the basic settings.
English