Publicidad
Idiomas disponibles
Idiomas disponibles
PTO Belt Access
1. Properly stop and park unit (See
Operation on page 12).
2. Lower the mower.
3. Place seat in most rearward position.
4. Remove belt covers.
5. Place foot board in open position
(Figure 18).
1
2
1. Footboard in
2. Support
open
Frame
position
3. Pivot
Figure 18
Replacing
Mower
Belts
NOTE: Long mower belt must be removed to
remove short mower belt.
_
AUTION: Use care when
releasing idler spring tension.
Keep body parts well away from
idlers when performing this
operation.
1. Slowly release the tension on the long
mower belt idler until all the tension is
removed from the springs.
2. Remove long mower belt from left blade
spindle and remove from deck.
3. Slowly release the tension on the short
belt idler until all the tension is removed
from the springs.
4. Remove short mower belt from right
blade spindle and from deck. Idler pivot
bolt must be loosened slightly to gain
clearance to remove belt from under
idler pulley (Figure 19).
5. Arrange new mower belt(s) on deck
(short belt first). Retighten short mower
belt idler pivot bolt. Install belts on
sheaves. Put belts onto center sheave
last.
6. Replace belt covers and return foot
board to closed position.
2
1
7
1. PTO Mower Belt
2. Mower Drive Belt
3. Springs
4. Mower Drive Belt Idler
5. PTO Mower Belt Idler
6. Mower Clutch Sheave
7. Center Sheave
Figure 19
Replacing
the Hydro
Pump
Belt
1. Properly stop and park unit (See
Operation on page 12).
2. Remove the PTO belt from the mower
clutch sheave (See Replacing Mower
Belts on page 25).
,_
CAUTION:
Use care when
releasing idler spring tension.
Keep body parts well away from
idlers when performing this
operation.
3. Slowly release the tension on the hydro
pump belt idler until all the tension is
removed from the springs.
4. Remove old hydro pump belt from right
hand hydrostat sheave first (Figure 20).
GB - 25
Publicidad
