Installation Instructions - Avintage AVV80 Manual De Utilización

We recommend that you make a note of its serial number in this booklet prior to installation, so that you can
refer to it later (technical work, request for assistance, etc.)
Once it is installed and loaded, access to it is not so easy.
CAUTION: No assistance can be provided without this information.

4. INSTALLATION INSTRUCTIONS

Before using your wine cellar
 Remove the inner and outer packaging. Remove your wine cellar from the transport pallet by unscrewing the
two screws on the frame at the back of the device.
 Before connecting the cellar to the electrical socket, leave it in position for 24 hours. This will reduce the
possibility of malfunction of the refrigeration circuit due to transport.
 Clean the inside using a soft cloth and lukewarm water.
Using your wine cellar
Your wine cellar must be positioned in a room with an ambient temperature between +10°C and +32°C.
Alternatively, if the cellar is fitted with the winter system, the range is extended to 0°C to 32°C.
Installing your wine cellar
 This wine cellar is designed for free-standing installation.
 Position it in a place with sufficient strength to support its weight when loaded.
 To get the best from your appliance with the lowest energy consumption, do not place the appliance close to
a heat source (heater, cooker, etc.), do not expose it to direct sunlight, and do not place it in a room which is
too cold.
 Screw the stopper supplied inside the wine cellar to maintain a 10 cm minimum distance between the back of
the cellar and the wall in front of it is placed. Ensure that your wine cellar is perfectly horizontal, then slightly
raise the two front feet (use of a spirit level is recommended). This will prevent any movement due to
instability, causing noise and vibration, and will ensure that the door seals perfectly.
39