Quick Reference - SELFSAT Snipe Manual De Usuario

3-3. Quick Reference

Classification
Setting
&
Connecting
Operating
(Searching the satellite)
10
1. Take out the antenna from carrying case, and place it on the flat ground (or
mount it on the top of the camper)toward the South sky & no obstacle.
2. Connect between the left port of the antenna, which located in the back
side of the main unit, and controller using controller cable.
a. One end of the controller cable connect to "controller" port of the main
unit of antenna.
b. The other end of the controller cable connect to the port of the controller.
3. Connect the power cable to controller .
a. If you use the power source from car, using cigar jack to connect the
power to controller.
b. Otherwise, using adapter cable to connect the power to controller.
4. Connect between the right port of the antenna, which located in the back
side, and receiver using receiver cable.
1. Switch on with the "Power switch" button on the top of the controller.
2. Upon power on, all LED will be flashing twice.
3. Wait until "HOME State" light & one "Satellite LED" light, which you set
previously or the first satellite in the controller (Turksat), will be solid on.
4. Select the desired satellite using the "UP/DOWN" buttons, then press the
"OK" button to accept.
5. When the satellite LED light is start to flashing, wait until it become solid on.
6. When the satellite LED light become solid on, watch the satellite TV!!
WARNING
When you move SNIPE, make sure the position of antenna should be in
Home position.
NOTE
Purchase Power Adapter separately from us, or if you purchase it on your
own, purchase ONLY 18V / 3.3A which is certified.
NOTE
Car Mounting Instruction will be provide separately.
Description