Doc Eco Maintenance And Management; Battery Management And Charge; Cleaning; Maintenance And Repairs - Nilox DOC ECO Manual De Instrucciones

DOC ECO MAINTENANCE AND MANAGEMENT

B
ATTERY MANAGEMENT AND CHARGE
•
Charge time: about 480 minutes
•
Make sure DOC ECO is OFF when charging.
•
Insert the power cord in the DOC ECO power port and insert the other end in an electrical
socket.
•
Only use the certified DOC ECO charger.
•
Do not deform, alter or remove the battery.
•
Do not charge or leave the battery near heat sources.
•
Avoid connecting the + and - poles with metallic objects.
•
Store the battery separately to avoid it coming into contact with metallic materials.
•
Avoid subjecting the battery to violent hits such as throws or falls.
•
Charge the battery at room temperature (5-26°C).
•
Do not charge the battery in very humid areas.
•
Do not use the charger if the cables or connectors are damaged.
C
LEANING
•
Always close the power port before cleaning.
•
Always disconnect DOC ECO from the charger before cleaning it with liquids.
•
Do not use thinners or other solvents to clean since they could damage surfaces.
•
Use a damp cloth to clean plastic parts.
•
Do not clean DOC ECO with pressure jets or by submerging it in water.
M
AINTENANCE AND REPAIRS
•
Frequently check the wheels and replace them when necessary.
•
To lengthen working life, avoid parking DOC ECO outdoors or in humid or wet areas.
•
Frequently clean the rear mudguard brake. Check correct brake operations by testing it at
low speed before use.
R
EMOVING THE FRONT WHEEL
Proceed as follows to change the front wheel:
Remove screws (AB) using the 5 mm Allen key, as shown in the fig.
Deflate the wheel to remove it (valve C). Loosen screws D, R, F, G and remove the wheel hub to remove
the wheel.
EN
10