Alemite 575-A1 Manual Del Usuario página 8

SER 575-A1
CAUTION
Do not operate the Charger if it has received a
sharp blow, been dropped, or otherwise damaged
in any way.
Do not disassemble the Charger.
Do not charge the Battery when the temperature
is below 50° F (10° C) or above 95° F (35° C).
The Charger is designed to operate on standard
household electrical power. Do not attempt to use
it on any other voltage.
Consecutive charging may cause overheating. If
you need to recharge the Battery consecutively,
wait for about 15 minutes to allow the Charger
to cool.
Do not insert foreign material into the hole for the
Battery in the Charger stand.
Do not disassemble the Battery.
Do not Store the gun and Battery assembly
in locations where the temperature may reach or
exceed 104° F (40° C).
Do not short-circuit the Battery.
Do not discharge the Battery beyond normal use
limits. Further discharging (such as placing a
rubber band on the Trigger) can cause a deep
discharge which may result in the polarity
reversal of a cell rendering the Battery useless.
Do not place the Charger in an area of extreme
heat or cold. It works best at normal room
temperature.
The Battery contains rechargeable nickel-cadmium.
These batteries must be recycled or disposed of
properly.
Revision (4-13)
1-800-548-1191 - http://www.partdeal.com - info@partdeal.com
Battery Charger Operation
Charge the Battery only with the Charger provided.
Make sure power circuit voltage is same as that shown
on the charger specifications plate. Press down to ensure
the battery properly engages with the charger's contacts.
Function of Red and Green Lights
Red and Green Lights Alternate Flashing
Once the charger is powered on, the Red and Green
lights flash alternately for 2 times.
Both Lights Off
No battery
Red Light On
Battery Charging
Green Light On
Battery fully charged
Red Light Flashes
Battery overheating
cause a flashing red light. To restore the charging,
the battery pack needs to be taken out of the
charger for an approximate 30-minute cool down
prior to the next charging.
to a reason below:
A. Long continuous running
B. Hot ambient temperature
C. One or more cells are damaged
After normal usage, 1 hour of charge time is required
to be fully charged. A minimum charge time of 1 to 1-1/2
hours is required to recharge a completely discharged
Battery.
The Battery will become slightly warm to the touch
while charging. This is normal and does not indicate a
probl em.
Changes Since Last Printing
Battery section edit
8
Cordless Grease Gun
An overheated battery* in the charger may
* The battery overheating could be attributed
Alemite, LLC