Wolf ICBSRT304 Instrucciones De Instalación página 16

W O L F
S U R FA C E
I N I T I A L L I G H T I N G
The surface burners use electronic igniters in
place of standing pilots. When the sealed
rangetop control knob is pushed in and turned
to the
to light the burner. This sparking continues
until the electronic ignition senses a flame. If
the burner fails to ignite after 10 seconds,
return the knob to the
to ignite by turning the knob back to the
position.
Be sure to place the burner heads and caps on
each burner base and position the burner
grates over the burner bases and heads before
lighting.
To check operation of the surface burners,
push in and turn each control knob to the
position. The flame should light within four
seconds.
If the burners do not light properly, turn
control knob to the
burner heads and caps are in the proper
position. Check that the power supply cord is
plugged in and that the circuit breaker or
house fuse has not blown. Check operation
again, if the burners do not light properly at
this point, contact a Wolf authorized service
center.
IMPORTANT NOTE: Initial lighting of the
surface burners may take slightly longer, as air
in the system must be purged before gas can
be supplied to the burner.
16
S E A L E D B U R N E R R A N G E TO P
B U R N E R S
position, the system creates a spark
position and attempt
position. Check that the
S E A L E D R A N G E TO P
If it is necessary to remove the sealed
rangetop for cleaning or service, shut off the
gas supply. Disconnect the gas and electric
supply. Remove the mounting brackets on the
right and left side of the burner box and
remove the sealed rangetop. Reinstall in the
reverse order and check the gas connection for
leaks.
T R O U B L E
S H O O T I N G
IMPORTANT NOTE: If the sealed rangetop
does not operate properly, follow these trou-
bleshooting steps:
Verify that power is being supplied to the
sealed rangetop.
Check that gas valves are turned to the ON
position.
Check the gas supply and electrical
connections to ensure that the installation
has been completed correctly.
Follow troubleshooting procedures as
described in the Wolf Sealed Burner
Rangetops Use & Care Information.
If the sealed rangetop still does not work,
contact a Wolf authorized service center. Do
not attempt to repair the sealed rangetop
yourself. Wolf is not responsible for service
required to correct a faulty installation.
R E M O V A L