After Use Of The Vacuum Cleaner - Hilti VC 20­U Manual De Instrucciones

1. Disconnect the supply cord plug from the power outlet.
2. Open the two catches.
3. Lift the vacuum cleaner top section away from the waste material container.
4. Carefully release the mouth of the dust bag from the adapter.
5. Close the mouth of the dust bag with the slider.
6. Clean the waste material container with a cloth.
7. Fit a new paper dust bag in the waste material container.
8. Fit the vacuum cleaner top section onto the waste material container and close the
two catches.
6.5 Changing a plastic dust bag
1. Disconnect the supply cord plug from the power outlet.
2. Open the two catches.
3. Lift the vacuum cleaner top section away from the waste material container.
4. Use a cable tie to close the plastic dust bag below the punched holes.
5. Remove the plastic dust bag.
6. Clean the waste material container with a cloth.
7. Fit a new plastic dust bag (see instructions printed on it) in the waste material container.
8. Fit the vacuum cleaner top section onto the waste material container and close the
two catches.
6.6 Picking up liquids
CAUTION
Risk of injury. Hazardous material that has been picked up may escape if a filter
element is not used.
▶ Never use the appliance without a filter element.
1. Check the container level monitoring system. → page 12
2. If possible, use a separate filter element for wet applications.
Note
The Hilti VC 20/40 universal (2121387) filter is recommended.
3. After picking up liquids, open the two catches.
4. Lift the vacuum cleaner top section away from the waste material container and place
it on a level surface so that the filter element can dry.
5. Empty the waste material container and use a water hose to rinse it out. Use a brush
to clean the electrodes and clean the filter element, after allowing it to dry, by wiping
it off with your hand.
6. Allow the waste material container to dry.

6.7 After use of the vacuum cleaner

1. Switch off the electric tool.
2. Turn the vacuum cleaner control switch to the "OFF" position.
3. Unplug the vacuum cleaner's supply cord from the power outlet.
4. Coil up the supply cord and hang it on the hook.
5. Empty the container and clean the appliance by wiping it with a damp cloth.
6. Coil up the suction hose.
7. Store the vacuum cleaner in a secure, dry place where it is inaccessible to unauthorized
users.
10
3
4