BK Precision ISOPACK TR-110 Manual De Instrucciones página 4

MAINTENANCE
A 3A fuse protects the unit from excessive overload on the ISOLATED outlets. If the pilot
lamp will not light and there is no output from the ISOLATED outlets, check the fuse. It is
located on the side of the unit adjacent to the power cord. Replace only with a 3A, slow-blow
type 3AG fuse. Correct the overload condition before re-applying power.
The TR-110 fuse does not affect the DIRECT outlets. If there is no output from either the
ISOLATED or DIRECT outlets, check the fuse or circuit breaker panel of your building for the
outlet being used to power the ISOPACK. Correct any overload condition.
SPECIFICATIONS
Input Voltage
Output Power Rating
Direct
Isolated
Connections
Direct
Isolated
Output Selection
Direct
Isolated
Regulation
Isolation
Size (W x H x D)
Weight
* Intermittent usage: 5 minutes ON followed by 5 minutes or longer OFF.
** Output voltage rated with input at 120 volts.
NOTE: Specifications and information are subject to change without notice. Please visit
www.bkprecision.com
105-130VAC, 60Hz
500VA
350VA continuous, 500VA intermittent *
Duplex outlet (3 conductors)
Duplex outlet (3 conductors)
Convenience duplex outlet provides line voltage for auxiliary
Equipment up to 500VA
Two 3 position slide switches provide 9 combinations of
Voltage selection from 90 to 140 volts **, up to 350VA
continuous or 500VA intermittent *. Self-contained power
switch with pilot lamp.
No load to full load (350VA), voltage change is less than 4%.
Typical leakage current, primary to secondary, 0.1mA.
5.5" x 5.125" x 8" (13.97 x 13 x 20.3cm)
11 lbs. (4.99Kg.)
for the most current product information.
4