Installation; Preparing For Installation - Glacier bay 67778-0001 Guía De Instalación Y Cuidado

Installation

1

Preparing for installation

CAUTION: Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply.
□
Before installation, remove the quick connector
(F) from the free end of the hose by unscrewing
it in a counterclockwise direction.
□
Unscrew the nut (D), and remove the
washers (B & C).
NOTE: If installing the faucet assembly (A) without the
escutcheon, begin with step 2. If installing the faucet
assembly (A) with the escutcheon, begin with step 3.
B
C
D
2
A
E
F
19
Installing the faucet assembly
NOTE: This step is for no escutcheon installation (optional).
If the escutcheon will be used, install the faucet assembly
as described in step 3.
□
Before installation, ensure that the ange (G)
is placed on the bottom of the new faucet
assembly (A).
□
Retract the hose (1) up through the faucet body
until the hose tting is ush with the bottom of
shank (2). Do not pull the hose tting past the
shank.
□
Insert the faucet body through the hole in the
sink.
NOTE: Do not feed the hose (1) back down through the
spout until step 6.
G
A
2
1