Installing The Remote Control - Grohe Sensia ARENA 39354SH0 Manual De Instrucciones

Secure the ceramic bowl onto the wall.
Note
• Secure the ceramic bowl together with the
hexagonal nuts supplied with the tank.
Check whether the ceramic bowl is horizontally flat.
Note
• If necessary, adjust the flatness of the bowl by
loosening the hexagonal nuts in step
Remove the packaging under the ceramic bowl.
Cut the protection sheet sticking out around the
ceramic bowl.
Seal the edges where the protection sheet, toilet, and
wall meet.
Installing the E-bidet (Seat Unit)
Thread the power cord and water supply hose.
Place the packaging sheet kept in step
hook the power cord and water supply hose into the
slit.
Connect the power cord.
For the Standard (39354SH0/39414SH0) model
Connect the water supply hose, and secure it with the
clip. Check if the water supply hose is properly
secured with the clip.
Note
• If the clip has not attached properly, remove it and
attach it again. To open the clip, insert a flat-blade
screwdriver and then press it downward and push it.
For the Display (18801SH0) model
Attach the strainer.
For the Standard (39354SH0/39414SH0) model
Twist the lever of the water supply hose vertically.
For the Display (18801SH0) model
Thread the tube and place the E-bidet (seat unit) on
top of the ceramic bowl.
Slightly tilt the back of the E-bidet (seat unit) and
insert it into the ceramic bowl.
Note
• Make sure that the hooks under the E-bidet (seat
unit) are secured into the mounting base of the
ceramic bowl.
• When the E-bidet (seat unit) is locked, you will hear
a "click" sound.
• You can detach the E-bidet (seat unit) by following
the steps below.
Remove the side lid of the E-bidet (seat unit).
Press the lever. Use a screwdriver if you cannot
reach it by hand.
Pull the E-bidet (seat unit) out upward while
pressing the back part.
Store the power cord in the groove on the underside
of the bowl.
Open the water shutoff valve.
For GROHE tank, adjust the amount of flushing water.
Then reattach the actuation plate.
Turn on the power breaker.
.

Installing the Remote Control

Remove the remote control from the holder.
Insert the batteries.
Note
• Vertical lines may appear on the screen when the
batteries are removed. This is not a malfunction.
These vertical lines will disappear when batteries are
inserted into the remote control.
Insert the small nut into the groove on the back of the
remote control.
of and
Decide the installation position of the remote control.
Note
• Leave a space above the remote control's mounting
position.
Mount the remote control holder onto the wall.
For plasterboard or plywood that is thinner than 5 mm
For concrete
Attach the remote control in the holder.
Secure the remote control to the holder with the small
washer and screw.
Testing
Cover the seat sensor with a piece of rag or paper
and place the spray hood under the toilet seat.
Switch the POWER of the E-bidet (seat unit) to on (|).
Then press the SETTING button ( ) of the remote
control to register it to the E-bidet (seat unit).
Confirm that water sprays for rear and front washing.
Remove the spray hood.
Confirm warm air. Attach the banderole to the seat lid.
9
GB