DeWalt DW626 Manual De Instrucciones página 26

E N G L I S H
• Make sure the plunge limiter is always locked
before switching on.
• Select the optimal speed using the electronic
speed control dial.
Switching on and off (fig. A)
• On: pull the switch (1) up.
• Off: press the switch (1) down.
Loosen the plunge limiter and allow the
router carriage to regain its rest position
before switching off.
Using guide bushes (fig. G)
• Secure the template to the workpiece using end
clamps.
• Select and install an appropriate guide bush (22).
• Subtract the diameter of the cutter from the
outside diameter of the guide bush and divide by
2. This is the difference between template and
workpiece.
If the workpiece is not thick enough,
place it on a piece of waste wood.
Guiding off a batten
Where an edge guide cannot be used, it is also
possible to guide the router along a batten clamped
across the workpiece (with an overhang at both ends).
Freehand routing
Your router can also be used without any sort of
guide, e.g. for signwriting or creative work.
Make shallow cuts only!
Use cutters with a max. diameter of 6 mm.
Routing with pilot cutters (fig. B)
Where a parallel guide or guide bush are
inappropriate, it is possible to use pilot cutters (16)
for cutting shaped edges.
Consult your dealer for further information on the
appropriate accessories.
26
Maintenance
Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
Keep the ventilation slots clear and regularly clean
the housing with a soft cloth.
Unwanted tools and the environment
Take your tool to an authorized D
agent where it will be disposed of in an
environmentally safe way.
WALT repair
E