Getting Started; Replacing The Battery; Operational Summary - Bushnell TOUR V4 SHIFT Manual Del Usuario

GETTING STARTED

REPLACING THE BATTERY

Your TOUR V4 SHIFT comes with a battery already installed, so it's ready to use right away. To replace the
battery, remove the battery cap by lifting the battery cap tab and then rotating counter clockwise. Insert a
CR-2 3-volt lithium battery into the compartment negative end first, then replace the battery cap.
NOTE: It is recommended that the battery be replaced at least once every 12 months.
Low Battery Indicator: When one bar is shown on the battery icon, the battery is low and should be replaced.
If the battery goes below the safe operating level (affecting accuracy of readings), the battery icon will flash
and the unit will not range.
Full Charge LowBattery
ADJUSTING THE EYEPIECE
Your TOUR V4 SHIFT is constructed with an adjustable eyepiece (+/- 3 Diopter Adjustment) that allows one to
focus the LCD display relative to the image. Simply rotate the eyepiece until the reticle and object distanced
to are both in focus to your eye.

OPERATIONAL SUMMARY

While looking through the 5x eyepiece, depress the POWER/FIRE button once to activate the in-view Liquid
Crystal Display (LCD). Place the aiming circle (located in the center of the field of view) upon a target at
least 5 yards away, depress and hold the POWER/FIRE button down until the range reading is displayed
near the bottom of the in-view display. Crosshairs surrounding the aiming circle indicate that the laser is
being transmitted. Once a range has been acquired, you can release the POWER/FIRE button. The crosshairs
surrounding the aiming circle will disappear once the POWER/FIRE button has been released (i.e. the laser is
no longer being transmitted). Note: Once activated, the LCD will remain active and display the last distance
measurement for 10 seconds. You can depress the power button again at any time to distance to a new target.
6