Machine Working Hour Check; Fuse Check/Replacement - Viper AS5160 Manual Del Usuario

USER MANUAL

MACHINE WORKING HOUR CHECK

1. Turn the ignition key (A, Figure 22) to "I".
2. Press the switch (B), the hour meter (C) begins to work and
it at the same time shows the total number of working hours
(scrubbing/drying) performed by the machine.
3. Release the switch (B).
4. Turn the ignition key (A) to "0".

FUSE CHECK/REPLACEMENT

1. Turn the ignition key (A, Figure 22) to "0".
2. Disconnect the power supply cable (C, Figure 23) from the
electrical mains.
3. Remove the screws (C, Figure 24) on control panel (D),
then turn over the PCB to find the fuse (A, B, Figure 24).
4. Check/replace the following fuses:
A) F1 fuse, low power circuit fuse: (5A)
B) F3 fuse, Brush release fuse: (20A)
5. Perform steps 1 to 3 in the reverse order.
6. Check/press down or replace the following breakers:
E) F5 breaker, vacuum motor circuit breaker: (30A) (only
for disc machine)
F) F4 breaker, drive system circuit breaker: (17A) (*) (only
for disc machine)
G) F2 breaker, brush motor circuit breaker: (30A)
(*): Only for machine with traction
B
A
C
Figure 23
B
A
B
C
D
VACUUM TRACTION BRUSH
E
26
ENGLISH
A C B
Figure 22
F G
Figure 24