Operation; How To Avoid And Solve Possible Problems - Ebode IR Link Serie Guía De Usuario

Remove the paper backing from one of the IR Emitters, exposing the adhesive surface.
Apply the Emitter directly onto the centre of the sensor "window" on one of your
components.
Note: The Emitters have self-adhesive tape on the back. Use this to stick them onto the IR
eye of your equipment. This should be done very carefully and precisely. Test the position
of the IR Emitters first, before you finally stick them onto the eye.
Step 4: Place a 9 Volt battery (EN22 or PP3) to the battery connector of the IR Hub circuit.
Be sure to observe correct polarity!
ATTENTION: If you are only using one appliance, then you do not need to use the
additional IR Emitters. Never remove these from the wire! Just dress up the wire and leave
close to the Hub.

7. Operation

Normally your ebode IR Link B Receiver will be in a "sleep" mode to maximize battery life.
When in sleep mode, the range between it and your handheld remote is limited to
approx. 4 meter or less.
To activate the system, simply point your remote at the ebode IR Link B IR Receiver from a
nearby location and press one of the buttons. The LED in the front of the receiver will flash
to confirm reception and that the unit is activated to full sensitivity. When activated, the
IR Link B will operate up to a distance of 4 – 8 meters over an angle of ± 30 degrees off
axis. The ebode IR Link B will automatically go back into "sleep" mode after approx. 1
minute.

8. How to avoid and solve possible problems

Although the ebode IR Link B is equipped with proprietary eIR x (pronounced Irex)
2 TM
Technology, which guarantees a high level of immunity of InfraRed noise of direct sunlight,
CFL lighting and Flat Panel TV's (including Plasma, LCD and LED), in rare cases, the IR
Receiver may have to be moved to a different location if the unit is picking up
10-8-2010 5 ebode IR LINK B