Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
LUBRmCATmON
Use only high quality
detergent
oil rated
with API service
classification
SF-SJ.
Select the oil"s SAE viscosity
grade
according
to your expected
operating
temperature.
SAE VISCOSITY
GRADES
NOTE:
Although
multi-viscosky
oils
(5W30,
10W30
etc.)improve
starting
in
cold weather,
these muki-viscosity
oils will
result in increased
oil consumption
when
used above 32°R
Check your engine
oil
level more frequently
to avoid possible
engine
damage
from running
low on oil.
Change
the oil after every 25 hours of
operation
or at least once a year if the unit
is not used for 25 hours
in one year.
Check
the crankcase
oil level before
starting
the engine
and after each five (5)
hours of continuous
use. Tighten
oil plug
securely
each time you check
the oil level.
TO CHANGE
ENGINE
OIL
NOTE:
Before
tipping
trimmer
to drain oil,
empty
fuel tank by running
engine
until
fuel tank is empty.
1.
Disconnect
spark
plug wire from spark
plug and place wire where
it cannot
come in contact
with spark
plug.
2.
Remove
engine
oil cap; lay aside
on a
clean surface.
3.
Tip trimmer
on its side as shown
and
drain oil into a suitable
container.
Rock
trimmer
back and forth to remove
any
oil trapped
inside
of engine.
Container
4.
Wipe off any spilled
oil from trimmer
or
side of engine.
5.
Fill engine
with oil (See "ADD OIF' in
the Operation
section
of this manual).
6.
Replace
engine
oil cap.
7.
Reconnect
spark
plug wire to spark
plug.
AIR FmLTER
Your engine
will not run properly
and may
be damaged
by using a dirty air filter. Re-
place the air filter every
100 hours
of op-
eration
or every season,
whichever
occurs
first.
Service
air cleaner
more often under
dusty conditions.
Do not wash air filter.
TO CHANGE
AIR FILTER
1.
Remove
the air filter by turning
clock-
wise to the stop and pull away from
collar.
2.
Remove
filter from inside
of cover.
3.
Clean
the inside of the cover and the
collar
to remove
any dirt accumulation.
4.
Insert
new filter into cover.
5.
Put air filter cover and filter into collar
aligning
the tab with the slot.
6.
Push in on cover and turn counter-
clockwise
to tighten.
Collar
Clip
\
TURN CLOCKWISE
TO
REMOVE
Slot
Air filter
Tab
Air filter cover
TURN
COUNTER-
CLOCKWISE TO TIGHTEN
11
Publicidad
Tabla de contenido
