Technical Data; Cleaning, Maintenance And Ordering Of Spare Parts - HERKULES HKS 85 Manual De Instrucciones

Anleitung HKS 85_SPK7:Anleitung SKS 85 E_D
GB
entire chain has been sharpened, mark the first link
(e.g. with chalk). Once all cutting links on one side
have been sharpened, the grinding angle must be
set to the same number of degrees on the other side.
You can then begin to sharpen the links of the other
side(without having to make any further adjust-
ments).
5.7. Set the depth limiter spacing (Fig. 12/13)
Once the chain has been fully sharpened, you must
make sure that the depth limiter spacing is kept (the
depth limiters (1) must be lower than the cutting links
(2). You may need to file the depth limiters (1) to the
specifications for your chain using a file (3) (not
included in delivery).

6. Technical data

Rated voltage: 230V
Power input:
Idle speed:
Adjustment angle: 35º to the left and right
Grinding wheel Ø (inside):
Grinding wheel Ø (outside): max. 108 mm
Grinding wheel thickness:
L noise level:
pA
L peak noise level:
WA
Totally insulated:
Weight:
7. Changing the grinding wheel
Important! Always switch the appliance off and
unplug the power plug before carrying out any main-
tenance.
1. Remove the grinding wheel (Figs. 14-16)
2. Fit a new grinding wheel
3. Assemble in reverse order
Do not use grinding wheels that are worn, broken,
cracked or otherwise damaged.
Use only genuine grinding wheels.
8. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
10
06.03.2007
8.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the tool immedia-
tely after you use it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the
toolʼs plastic parts. Ensure that no water can get
into the interior of the tool.
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.3 Ordering replacement parts
Please provide the following information on all orders
50Hz
~
for spare parts:
85 watts
Model/type of tool
-1
4800 min Article number of the tool
ID number of the tool
Number of the required spare part
23 mm
For our latest prices and information please go to
3.2 mm www.isc-gmbh.info
77 dB
90 dB
II / ®
2.15 kg
7:34 Uhr Seite 10